Many men's wigs are attached to the scalp with double-sided adhesives in today's world, but it is essential to ensure that these adhesives are thoroughly cleaned before each use. Because the glue will continue to accumulate, which has the potential to cause serious damage to the wig and will prevent new film from being pasted again if the film is not effectively cleaned and is left standing on the bottom of the wig net. This is due to the fact that if the film is not cleaned effectively and is left standing on the bottom of the wig net. As a result, I'm going to present the method of cleaning film to you today. We need a solution containing 91% isopropyl alcohol, cotton swabs, cotton designed for removing collodion, and antibacterial spray. These are the items.
If you want to remove the wig, it is best not to pull it directly off the head because not only will this pull the hair off the wig, but it may also cause damage to the scalp. If you want to remove the wig, it is best not to pull it directly off the head. If the bottom of the net is particularly thin and it is handled roughly, there is a good chance that it will tear, which will result in the net's premature demise. Therefore, before removing the wig, it is best to apply a solution of 91% isopropyl alcohol to the cotton swab, then use the cotton swab to wet the tape connecting the wig and the scalp, and then peel off the wig little by little. This is the best way to remove the wig without damaging the scalp.
Because there will be residual colloid on the bottom of the removed wig net and on your scalp, let's take a look at how to remove them properly so that we can move on to the next step of the wig cleaning process. Of course, this is not the end, but Brazilian hair the beginning of the process of cleaning the wig.
1. Apply some collodion remover to a rag and wipe the film.
Remove the film from the bottom of the net by tearing it off, then taking a piece of collodion remover and rubbing it back and forth over the area where the hair block tape was adhered to get rid of the film's stickiness.
2. Take the film off of it.
If the film loses its stickiness after being wiped with cotton that removes collodion, it should not be difficult to remove.First, locate the spot where the Peruvian Hair Weaves tape has become loose, then carefully lift it with your fingers, and finally, rip off all of the tape along the direction that the tape is going.
3. Make sure the hair is clean and condition it.
After removing the tape, you will then be able to clean the wig.Wet the hair with water from the sink, apply shampoo in an even layer (you don't need a special shampoo for washing hair because we normally use it for that), and then clean the hair as well as the bottom of the net.It is important to keep in mind that when applying conditioner, it is best to avoid applying it to the roots of the hair. This is because applying conditioner to the roots of the hair may cause the adhesive tape to become less sticky, causing it to not adhere to the scalp as firmly as it did before.
4. Let the hair distributor wholesale surface air dry
After cleaning the hair, it is strongly recommended that you do not use a hot hair dryer to dry the hair, as this can easily damage the wig.The most effective method is to hang it up in a well-ventilated and cool location so that it can dry naturally.You need to make sure that your scalp is clean before you put it back on.In the event that there are stray hairs growing out, you will need to shave them off before using the gel because, if you don't, the gel will adhere to the hair, and removing it will be a very excruciating experience for you.In addition to that, you are required to use an antibacterial and no-clean cleaning spray.Before putting on the wig, you should spritz it twice onto the scalp.In addition to preventing the growth of microorganisms on the scalp and relieving itching caused by those microorganisms, it can also keep the wig sanitary and protect the ecological health of the scalp..
Before purchasing a wig, many people have concerns about the potential damage that the wig could cause to their scalp. They may also believe that wearing a wig will prevent new hair from growing because the hair follicles will be blocked. In point of fact, if you continue to lose your hair, eventually some of the hair follicles will have wholesale bundles gradually shrunk, and some of the hair follicles will even have closed, which is why many people end up bald. And even after removing the wig, there is still a lot of work to be done in terms of cleaning and maintenance, which means that the damage to the hair follicles on the scalp that is caused by wearing a wig is actually quite minimal.
The first step is to care for the wig by keeping it clean and well-maintained. When you buy a wig, it comes with a few accessories for cleaning and maintenance, such as no-clean antibacterial spray. This spray can prevent the growth of scalp microorganisms and scalp itching, as well as keep the wig hygienic and the scalp ecologically healthy. After you buy the wig, you will receive these accessories along with the wig. Medical biological double-sided adhesive tape, waterproof and sweat-proof, firm and natural; there is no need to worry about the wig falling off at any time; at the same time, it adopts a medical desensitization design, which is very friendly to people who have sensitive scalps.
The wig hydrating and smoothing care spray can protect the wig from roughness, knotting, and static electricity. It can also add nutrition to the hair, which makes the wig hair naturally soft and reduces the likelihood that the wig hair will break. Regardless of how thoroughly a professional collodion removal is performed, some residual colloids will always remain after the wig has been worn. In addition to assisting in the removal of these colloid residues, professional collodion removal can also help restore the viscosity of inactive double-sided adhesive, allowing it to be reused.
The anti-static design of the special anti-static air cushion comb for wigs can effectively reduce hair damage. At the same time, the rubber air bag has air bag holes, which rebounds well and can massage the scalp while combing hair. This comb is intended for use with wigs. The specialized hairnet support bracket for wigs is designed to prevent the hairnet from collapsing, to maintain the shape of the hairnet, to be simple to install and disassemble, and to be practical for storage and transportation. In the event that the hair on your top becomes thinner or the hairnet sustains minor damage during the recycling process, it will be sent back to the factory to be repaired in order to bring your hair block as close as possible to its initial condition.