When the hedge machine is used, it is found that the effect of pruning is not as good as before, then it is necessary to adjust the electric Arc Blade hedge trimmer, how to adjust it? The following hedge machine technicians will introduce you to the adjustment method:

Electric Arc Blade hedge trimmer is fixed by nuts and screws. When fixing, pay attention to loosen the nut first, and then turn the bolt clockwise until it does not move. Pay attention to the need to turn the screw up half a week. To ensure a good fastening, you must use a screwdriver. After the blade has been adjusted by bolts and nuts, it needs to be lubricated again to make it smooth.

If it is found that the blade is blunt and the electric hedge machine is not running smoothly, it is necessary to polish the blade, and the grinding of the blade surface or joint should be avoided when grinding.

When sanding the electric Arc Blade hedge trimmer, hold the sander at 45 degrees and sharpen the knife with the sanding edge.

When replacing the Arc Blade hedge trimmer, turn off the power to avoid injury caused by automatic startup. Wear gloves when replacing the blade to take protective measures. Its specific practices are:

Remove the old blade, fix the cutter by hand, loosen the blade nut, remove the bolt and blade, and remove all the bolts and nuts at the same time when removing the old blade. Install the new blade and tighten the nut. If there are weeds on the blade, keep it clean.

For the precautions of Arc Blade hedge trimmer replacement, if you do not know the model and size of the replacement blade, you can consult the manufacturer. The above is the adjustment method of electric Arc Blade hedge trimmer, which must ensure the sharpness and fastness of the blade when using the blade in daily life.

Arc Blade hedge trimmer https://www.keylead.cn/Electrical-Hedge-Trimmer-Arc-Blade