After the operation of each vertical Fully Automatic CNC Machine for a certain period of time, some components will inevitably have some damage or failure. In order to reduce the abnormal wear of the machine tool, extend the service life of the components as much as possible, and effectively avoid the occurrence of sudden failures, especially malignant accidents. The company shall do the daily maintenance of the vertical Fully Automatic CNC Machine to keep the vertical Fully Automatic CNC Machine in good working condition. The device aging process is reduced, and potential faults are discovered and eliminated in a timely manner to ensure safe operation. It is necessary to safely operate and maintain the vertical Fully Automatic CNC Machine, which is one of the key factors for the correct use of CNC equipment

1. The use of vertical Fully Automatic CNC Machine environment, in order to improve the service life of CNC equipment, it is generally necessary to avoid direct sunlight and other thermal radiation, to avoid environmental humidity, excessive dust or corrosive gases. It is also necessary to keep precision CNC equipment away from equipment with large vibration, such as punching machines and forging equipment.

2. Good power supply guarantee, in order to avoid the influence of large power supply fluctuation (greater than ±10%) and possible instantaneous interference signals, CNC equipment generally uses dedicated power supply (such as from the low-voltage distribution room for a separate CNC machine tool)*** It is best to add a voltage regulator, etc., which can reduce the influence of power supply quality and electrical interference.

3. Develop effective operating procedures, in the use and management of CNC machine tools, to develop a series of practical and effective operating procedures. For example, lubrication, maintenance, reasonable use and standardized transition system, which is the main content of the use and management of CNC equipment. It is one of the important measures to ensure the safe operation of CNC machine tools to make and obey the operating rules. Practice has proved that most failures can be reduced and avoided by following the operating procedures.

4. Vertical Fully Automatic CNC Machine should not be sealed for a long time, and it should be used in time after the purchase of vertical Fully Automatic CNC Machine, especially in the first year of use, most of the weak links prone to failure can be exposed, so that they can be eliminated within the manufacturer's warranty period. In processing, the opening and closing of the spindle of the CNC machine tool is minimized, which can reduce the wear of the clutch, gear and other devices. If there is no processing task for a long time, the CNC machine tool should also be regularly powered on, the best is to be powered on 1-2 times a week, each time running empty for about 1 hour, so that the heat of the machine tool itself can be used to reduce the humidity in the machine, avoid moisture damage to the electronic components, and can also be found in time whether the battery is insufficient alarm to prevent the loss of parameters set in the system.

5. Strictly abide by the operating procedures and daily maintenance system, the operator should strictly abide by the operating procedures and daily maintenance system, and the technical level and quality of the operator is an important factor affecting the frequency of equipment failure. When the machine tool fails, the operator should pay attention to retain the site, and truthfully explain the situation when the fault occurs to the maintenance personnel, so as to facilitate the analysis and diagnosis of the cause of the fault, and can be eliminated in time. ?

6 to prevent dust and dirt into the CNC device, the air in the processing workshop will generally have oil mist, dust and even metal powder, once they fall on the circuit board or electronic devices in the CNC system, it is easy to cause the insulation resistance between the components to decline, and even lead to damage to the components and circuit boards.

7. To prevent the system from overheating, you should check whether each cooling fan on the CNC cabinet works normally. Should be regularly every half a year or every quarter check whether the air duct filter is blocked, if the dust accumulation on the filter net is too much, it should be cleaned in time, otherwise it will cause the temperature in the CNC cabinet to be too high.

Fully Automatic CNC Machine https://www.zjshuangzheng.com/Fully-Automatic-CNC-Machine-Category